GMU:DIY-Microscopy/Maria: Difference between revisions

From Medien Wiki
Line 15: Line 15:


== Design ==
== Design ==
[[File:DIYmicroscopy.jpg|250px]]


I have decided to keep my microscope design fairly simple as I have no experience in creating such an object. My design will be made of perspex cut with the use of the laser cutter, but I will also create a .stl file for the 3D printer.
I have decided to keep my microscope design fairly simple as I have no experience in creating such an object. My design will be made of perspex cut with the use of the laser cutter, but I will also create a .stl file for the 3D printer.

Revision as of 20:00, 25 November 2012

Maria's Design


Deconstruction

DeconstructedMicroscope.jpg

The outer components of the webcam. I have removed the lens but will reattach it later. The plastic casing proved somewhat hard to remove. The plastic is tough and had to be removed with the help of pliers.


MicroscopeCircuitboard.jpg

This is the circuit board of the webcam. Three of the wires on the back side of the board became detached so I soldered them back onto the board. I have kept the button for capturing still images on the webcam for now, but may remove it later.


Design

DIYmicroscopy.jpg

I have decided to keep my microscope design fairly simple as I have no experience in creating such an object. My design will be made of perspex cut with the use of the laser cutter, but I will also create a .stl file for the 3D printer.

Media:Maria.pdf

This is the pdf version of the design for the laser cutter.