1,291
edits
→Printing
| Line 10: | Line 10: | ||
During the printing process parts might become loose. Mostly these are the screws on anything that is moving. Some places you should check are the screws of the x- and y-stepper motor pulleys. And the screws of the extruder gears. Also check if the belts are tight enough. Loose parts will make your print look ugly. | During the printing process parts might become loose. Mostly these are the screws on anything that is moving. Some places you should check are the screws of the x- and y-stepper motor pulleys. And the screws of the extruder gears. Also check if the belts are tight enough. Loose parts will make your print look ugly. | ||
===Printing=== | ===Printing=== | ||
Printing is fairly easy. Copy the G-code file to the sd card, put it into the RapMan controller and power it on. Then select you file and run it. | |||
===After you print=== | ===After you print=== | ||
After your object is printed there are some steps you might want to do: | After your object is printed there are some steps you might want to do: | ||