GMU:Tutorials/Performance Platform/Videowall Calibration

From Medien Wiki

Introduction

The video wall consists of 4*4 screens, which are connected with each other with serial ports. And all the signal will processed by the signal box which will provide a HDMI port to connect to the computer. The signal from the computer can be then distributed through the box to each screen.


Useful links:

More info about the Screens: [1] Manual: [2]


 
Behind Video Wall
 
Signal Box



Part 1 With Remote Control

The infrared receiver is attached to the right side frame of the video wall. So the screen will react only when you target your remote control towards the infrared receiver. And the screens are actually connected in the order that the pictures showed below.

 
Remote Control
 
Infrared Receiver
 
Numbers Of All Screens



When you press the "menu" button on the remote control, you can activate the adjustment menu on the screen which is located on the lower right corner. That is actually no.1 screen. You can use the arrow buttons in the menu to do specific adjustments which will have an effect on all the screens. Detailed instructions can be found in the Manual PDF from page 41 to 51.

 
Picture
 
Display
 
Setup
 
Input


In order to change some settings for individual screens, you need to press "select" button, so that you can see each screen will display some informations containing the number of its own. Then you can choose the screen you want to adjust by pressing the corresponding number on the remote control. In this way, you can make some changes individually.

 
Select




Part 2 With Software

Softwares will be used:


 
User
 
Setup
 
Service
 
Status
 
Gamma
 
Preference
 
Reports