GMU:Tutorials/Performance Platform/Sound System Stereo

From Medien Wiki

Instroduction

In the Digital Lab you could find two kind of sound playing system: 『Stereo Sound System』and 『Multi-Channels Sound System』. In this case, I will introduce how to set up and playing your sound with Stereo sound system and some about trouble-shooting.


Circumstance Setting

There are totally four workstations in Digital Lab, and the right most one is used for dealing with sound playback. Location is shown below:

Venuediagram.png


Equipments you will use

  • RME Fireface UFX & Fireface 800 Audio Interface (Fireface UFX is a Audio Interface which support max. 30 signal inputs-outputs and 4Mics/Instrument and built-in preamps. To see more detail please visit the technical page.(RME Fireface UCX).
  • Power supplier for multiple speakers.
  • Sound workstation(The most right Mac Pro).
  • Last but the most important! Your sound player.

Let's play the Sound

Step 1- Connect the 3.5 phone jack wire to your sound player

Sound Cable.jpg


Step 2- Turn on 『Power supplier for multiple speakers』
The power supplier is located behind the right sight of video wall.

Power supplier.jpg
Power supplier
Power supplier


Step 3- Turn on 『RME Fireface UFX, FireFace 800 Audio Interface and the right side MacPro 』.

Audiointerface.jpg
MacPro.jpg


p.s.Make sure following the ordering of first turn on power supplier then audio interface, but turn off audio interface at first then power supplier. If you break this rule, the electrical peak will harm the audio system. We believe that this definitely is a bad news for all users.

Step 4- Setting up on RME Fireface UFX (For those who only want to play stereo sound, they don’t need to download the drivers and control panel. In the other word, you will need to install them if you want play multiple sound tracks.)

Example of control panel: TotalMix(For signal manage and post-mix)

TotalMix


- There are there main playback modes:

  • Phone output(extra monitor using)
phone output


  • Main output(What we use!)
Master output


  • ADAT output(Only for digital Optical system)
ADAT output


- You could press the knob(1) which is aside of power swith to change the between the above three modes, and turn voloume knob to adjust the volume you wish.

Volume adjust


Done!! Enjoy the Sound

Trouble shooting

Situation 1: You already plug in sound cable but not sound?

Answer:

  • Check if you turn both power supplier for speaker system and sound workstation(Mac pro)on.
  • Check if you already on the Fireface UFX and Fireface 800.

Situation 2: All are truned on but still no sound?

  • Check the Mac Pro and go to RME setting application(within the deck)to see if the sound card is selected to "Fireface 800" correctly.
  • Open up the totalmix control panel, sending sound signal from your playback device, then check it if there has signal in the stereo channal(Default is 1/2).
  • Check if you already choose the "Master out" playing mode correctly, and of course, volume up until you could listen somthing.