364
edits
→The printer queue
| Line 193: | Line 193: | ||
| | | | ||
|[[File:Crank_handle_part1.JPG|right|thumb|150px|]] | |[[File:Crank_handle_part1.JPG|right|thumb|150px|]] | ||
|- | |||
| | |||
|gearshell.bfb (part of the gear) | |||
|26.10. | |||
| | |||
|Robert S. und Florian M. | |||
| | |||
|several hours (only troubleshooting | |||
| | |||
|problems with the printbed level (was too close to extruder), flakes of PLA were sometimes extruded together with the ABS | |||
|leveling the bed, cleaning the extruder | |||
|no acceptable result, therefore nothing to photograph | |||
|} | |} | ||