364
edits
→The printer queue
| (2 intermediate revisions by the same user not shown) | |||
| Line 204: | Line 204: | ||
|problems with the printbed level (was too close to extruder), flakes of PLA were sometimes extruded together with the ABS | |problems with the printbed level (was too close to extruder), flakes of PLA were sometimes extruded together with the ABS | ||
|leveling the bed, cleaning the extruder | |leveling the bed, cleaning the extruder | ||
|no acceptable result, therefore nothing to | |no acceptable result, therefore nothing to photography | ||
|- | |||
| | |||
|gearshell2.bfb (part of the gear) | |||
|9.11. | |||
| | |||
|Robert S. und Florian M. | |||
| | |||
|approx. 3,5hours | |||
| | |||
|everything went perfectly fine | |||
| | |||
|[[File:Gearshell.JPG|right|thumb|150px|]] | |||
|} | |} | ||