GMU:3DIY/Printer queue: Difference between revisions

GMU:3DIY/Printer queue (view source)

700 bytes added , 9 November 2010

364

edits

@@ Line 181: / Line 181: @@
 |
 |[[File:Lamp.jpg|right|thumb|150px|]]
+|-
+|
+|crankhandle_p1.bfb (part of the gear)
+|13.10.
+|
+|Robert S. und Florian M.
+|
+|approx. 20 minutes
+|
+|everything went perfectly fine
+|
+|[[File:Crank_handle_part1.JPG|right|thumb|150px|]]
+|-
+|
+|gearshell.bfb (part of the gear)
+|26.10.
+|
+|Robert S. und Florian M.
+|
+|several hours (only troubleshooting
+|
+|problems with the printbed level (was too close to extruder), flakes of PLA were sometimes extruded together with the ABS
+|leveling the bed, cleaning the extruder
+|no acceptable result, therefore nothing to photography
+|-
+|
+|gearshell2.bfb (part of the gear)
+|9.11.
+|
+|Robert S. und Florian M.
+|
+|approx. 3,5hours
+|
+|everything went perfectly fine
+|
+|[[File:Gearshell.JPG|right|thumb|150px|]]
 |}