IFD:Eclectic Electric!/DocumentationWS2013

From Medien Wiki

Max Mustermann

Max_Mustermann/Week1


John Doe

John_Doe/Week1

Lydia

Martin

Aidas

Jonas L.

Thomas

Julia

Adrian

Exercise 1:

Today Jonas L., Aidas and I soldered our little LED-Exercise together.

At first we wanted to build a 2D Matrix out of the LEDs with separate buttons for every Light, but we decided to just handle every line of five LEDs separately in order to save some resistors and buttons.



We took 25 bright white LEDs and put them soldered them to our wires in parallel together with a 330 Ohm Resistor and a Push-Button for each set of five LEDs.

We used a piece of cardboard and pushed some holes with a needle in it to stabilize the LEDs before trying to solder everything together.


The estimated build time for this circuit was three to four hours.


Stefanie

Laura

Natalia

Sebastian

Light dependant LED

Group: Heinrich, Sebastian, Deniz

For our power circuit we used 5 LEDs and 5 light dependant resistors. The idea was to control the brightness of the LEDs with our fingers by blocking the light. We first tried it with just one, and later put everything together in a parallel circuit. While we were soldering we discovered that it is quite difficult to solder three cables at one connection. The picture below shows the result.

LightdendandentLeds.JPG Curcuitdiagram.JPG

Rodrigo

Tobias

Somayeh

Clotilde

Benjamin

Jonas K.

Heinrich

Light dependant LED

Group: Heinrich, Sebastian, Deniz

For our power circuit we used 5 LEDs and 5 light dependant resistors. The idea was to control the brightness of the LEDs with our fingers by blocking the light. We first tried it with just one, and later put everything together in a parallel circuit. While we were soldering we discovered that it is quite difficult to solder three cables at one connection. The picture below shows the result.

LightdendandentLeds.JPG Curcuitdiagram.JPG

Asu Ceren

Ives

Simon

Andre

Biters

Deniz

Light dependant LED

Group: Heinrich, Sebastian, Deniz

For our power circuit we used 5 LEDs and 5 light dependant resistors. The idea was to control the brightness of the LEDs with our fingers by blocking the light. We first tried it with just one, and later put everything together in a parallel circuit. While we were soldering we discovered that it is quite difficult to solder three cables at one connection. The picture below shows the result.

LightdendandentLeds.JPG Curcuitdiagram.JPG

Elahe